LEDs 12 Volts

Viewed products

Information

Conversion kit LED 12 V for DC flywheel mag ingitions VINTAGE View larger

Conversion kit LED 12 V for DC flywheel mag ingitions VINTAGE

New product

Allows the trouble free use of our LED Lamps in headlamps of Mopeds, Scooters, Off road-, trial and any other motorcycles with DC fly wheel ignition WITHOUT VOLTAGE REGULATOR. Up to 300% more light and overall illumination. Easy installation in a few minutes. Comes with mounting instructions in English. Consists of 1x LED 12V 24/48W BA20D 3000 Kelvin and 1 x Voltage limiter 12 V

More details

43.50EUR

Add to wishlist

More info

Flywheel magneto ignitions usually are used in motorcycles with 2 and 4 stroke engines from

50 – 250 cc and especially in smaller vehicles as mopeds and scooters.

Especially in vehicles from the 1950s to the 1980s the light system is often self regulating, will say it do not have an own voltage control or built in voltage regulator.

In this cases the light system is supplied directly through 1 – 2 light coils and voltage regulation is independently regulated by the overall consumption of the connected electronic devices as bulbs etc

Due to the lower power consumption of the LED bulbs voltage can increase. This fact in combination with faults and wear of certain electrical components as light coils, light switches, wiring etc. - especially in older vehicles - can cause voltage peaks of 30 Volts and above which can not be buffered by the LED driver and which finally will cause serious damage of the driver and the whole LED bulb..

We therefore strongly recommend the installation of a voltage limiter/regulator while using our LED bulbs in flywheel magneto ignition systems.

If your vehicle has a flywheel magneto ignition system and is already equipped with a voltage limiter/regulator we recommend – especially in older vehicles – to check the perfect function of this components before installing our LED bulbs.

Reviews

No customer reviews for the moment.

Write a review

Conversion kit LED 12 V for DC flywheel mag ingitions VINTAGE

Conversion kit LED 12 V for DC flywheel mag ingitions VINTAGE

Allows the trouble free use of our LED Lamps in headlamps of Mopeds, Scooters, Off road-, trial and any other motorcycles with DC fly wheel ignition WITHOUT VOLTAGE REGULATOR. Up to 300% more light and overall illumination. Easy installation in a few minutes. Comes with mounting instructions in English. Consists of 1x LED 12V 24/48W BA20D 3000 Kelvin and 1 x Voltage limiter 12 V

24 other products in the same category: